All data and codes contained in this catalog replace and supersede any information given by previous publications. Pto request form pdf data provided in previous publications may no longer be valid. THE ABOVE INFORMATIONCONCERNS YOUR SAFETY. All rotating parts must be guarded.
The tractor master shield, the driveline guards, and the implementinput connection shields form an interactive guarding system. Proper use and maintenance of the drivelineand shielding is of primary importance foroperator safety. A high percentage of driveline accidents occur when safety shielding is missing or does not function properly. Pavesi recommends the use of proper shields and guards for the driveline, tractor, and implement.
Use the implement only with the original driveline,which is compatible in length, power capacity, torque limiters, overrunning clutches, and shielding. The driveline and safety devices are designed specifically for the implement, and should be used exclusively for this purpose. Do not exceed the speed and power limits given by the operators manual. Do not overload the implement or suddenly engage the PTO clutch. 2 are smalland as equal as possible. The joint angles may vary widely during turns, but must never exceed 35 under power or 45а while rotating.
Disengage the PTO when the joint angles become excessive or too unequal. See Driveline applicationsӔ for more information. CONSTANT VELOCITY JOINTSConstant velocity joint can allow large joint angles -up to 50 or 80а depending upon the type. These joint angles should only be allowed for brief periods, for example during turning. The tractor printed on the shield indicates the tractorend of the driveline. Any torque limiter or overrunning clutch must be installed on the implement end of the driveline.